Pull as much of the gum off as you can before applying any products to it. Move the car into a shaded area so that the gum doesn’t melt while you’re working on it.
All you need is a bucket full of hot water and dish soap. You just need a squirt of dish soap in two cups of water. Dip a cloth into the bucket, and wet it. Then, gently wipe away any easily removable residue from the car’s exterior. [1] X Research source You want to avoid using anything too abrasive. It’s best to use a soft cloth when rubbing on a car exterior. You will want to repeat this process after you remove the gum too to get rid of any lingering residue. After removing the gum, you may need to apply a new coat of protective wax. If the water is hot enough, it may be possible to remove the gum using only soap and water.
You may need to repeat the process a second time if it doesn’t all come off. [2] X Research source Body solvents are specifically designed to be used on paint, so they are a good choice for cleaning a car exterior without damage. You can also try this with rubbing alcohol.
The good thing about bug and tar remover is that it’s designed specifically not to harm a car exterior because people usually use it to get rid of bugs that have flown into the car’s outside or tar that’s ended up on the vehicle. You could also apply the bug and tar remover to the gum by using a soft cloth. Rub the remover into the gum, until it starts to come off.
Goo Gone advertises that its product is safe for use on a car exterior if you follow the instructions for hard surfaces. To use either product, apply the product and wait three to five minutes. Pull the gum off. Use a clean cloth to wipe off excess gum. Wear safety goggles and solvent-resistant gloves when working with chemicals.
Spray the remover on the gum, and then remove the gum from the car. Some people also use WD-40 oil to remove gum, bugs, and other grime from a car exterior. [4] X Research source
You can find these cans in most hardware stores. Usually, people use compressed air to clean other things, such as removing residue caught inside a computer keyboard. However, they work on a car exterior too.
Take a small towel and wrap the ice cubes in it. Hold it on the gum for about five minutes. Once you remove it, the gum should be hard. Try to gently peel off the hard gum. You may need to repeat the process. You could also put the ice cube in a Ziploc bag. Wrapping it will keep it from dripping too much once it starts to melt.
Smear the peanut butter on the gum. Let it sit for three minutes, and then wipe it off with a damp rag. Peanut butter causes the chewing gum to lose its stickiness, and it becomes easier to pick out. You could also try putting body oil on the gum with the same principle in mind. Some people have also tried using eucalyptus oil with some success.
