Although suede paint is not the most commonly used, you can generally find it at most hardware stores like Home Depot. Ralph Lauren and Valspar both also make their own versions of brushed suede paint. [2] X Research source You can also create a suede finish on your wall by painting a coat of suede paint over a base coat of normal paint that will show through. If you choose to go this route, make sure you buy ordinary paint as well. [3] X Research source
To more easily spot flaws in the wall, turn off the lights, close the curtains, and hold a trouble light close to the wall to better spot holes and cracks. [6] X Research source
Use sandpaper or a sanding pole to sand the wall from floor to ceiling, focusing especially on areas you had to repair in the previous step. [8] X Research source Don’t apply too much pressure during the sanding process, especially if you’re using a sanding pole, or else you may inadvertently damage the wall itself. [9] X Research source Use a long-reach duster to remove any dust and debris from the wall, including any grit left over from the sanding process.
Once this is done, and any exposed light fixture wires are safely wrapped, you can restore power to the room. For larger fixtures, you can also cover them in painter’s plastic to protect them from unwanted paint, securing the plastic in place with painter’s tape. [11] X Research source
If you’re able to, move furniture out of the room you intend to paint in, to protect it from wayward paint droplets and to give yourself more work space.
You will use the paint in the pail when painting with your brush, and use the paint in the tray when painting with your roller.
Dip your brush so that about ⅔ of the bristles are loaded with paint. Paint using horizontal and vertical strokes as you paint alongside the ceiling or the side of the wall, respectively. Your paint strokes should run for roughly 12 inches (30 cm) at a time. [15] X Research source The technical term for this part of the painting process is “cutting in. ”[16] X Research source If you’re suede painting your wall by painting suede paint over ordinary paint, make sure you’re using the ordinary paint at this point. You won’t be using your suede paint until you apply the top coat. Use a slight wiggling motion to apply paint in tight corners or to fill in areas you missed on your first pass. [17] X Research source
Again, if you’re suede painting your wall by painting suede paint over ordinary paint, make sure you’re using the ordinary paint for this part of the process. Once the base coat has been applied, use the roller to apply another coat, this time only rolling from top to bottom along the entire wall, to smooth out any lap marks. [20] X Research source Wait 4-6 hours for this base coat to dry before moving on to your top coat. [21] X Research source
Starting in the top left corner of your wall, use your brush to paint an “X” shape roughly 1 foot (0. 30 m) long and 1 foot (0. 30 m) high. Then fill in the area around this X with more X’s roughly half as big and slightly overlapping one another. [23] X Research source Repeat this process, moving diagonally across the wall in the direction of the bottom right corner, until the entire wall is painted. [24] X Research source The sizes of your X’s do not need to be precise; in this instance, it’s more important that you use the proper technique of slightly overlapping X’s in order to bring about the suede finish.
