Correction fluid is made with chemical solvents because these solvents evaporate into the air more quickly than water. This means that you don’t have to wait very long for correction fluid to dry. If you can’t find the right thinner for your correction fluid, buy a generic brand instead. It won’t work as well as the correct fluid might but it will be much better than nothing.
Avoid inhaling the solvent fumes. Solvent fumes are hazardous to your health and can cause damage to your nervous system, liver and many other organs. [1] X Trustworthy Source US Occupational Safety and Health Administration U. S. government agency responsible for setting and enforcing workplace safety standards Go to source If possible, work outside. This provides the maximum amount of ventilation of hazardous fumes.
Don’t stir the correction fluid to mix in the thinner. This will cause the solvent to evaporate more quickly and expose you to more hazardous fumes.
If it’s not thin enough, add a few more drops of water and repeat the process. Some correction fluids react badly to added water. Always check the manufacturer recommendations before putting water in a correction fluid.
If it’s not thin enough, add another drop of nail polish remover and repeat the process. It’s easy to add too much nail polish remover. Therefore, you should only add one to two drops at a time. Otherwise, your correction fluid will be too thin.
Keep the Styrofoam insert. Some brands of correction fluid come with a Styrofoam insert that lines the top of the lid. Try to keep this insert in the package as it helps keep moisture in the container. [4] X Research source
If you or someone you know is addicted to using inhalants, contact an inhalant addiction treatment center[5] X Research source or call a toll-free addiction recovery hotline at 1-888-319-2606.
If the fluid is too thick, thin it out with the correction fluid thinner, water, or non-acetone nail polish remover described in the previous method. If the fluid is too thin, remove the cap and let the fluid sit in a well-ventilated place. Every ten minutes give the fluid a stir and test the thickness.
Each layer needs to dry for at least two minutes. If you try to paint on a new layer while the old one is still wet, the correction fluid will become clumpy and uneven. Once all of the layers are dry, you can draw or write over the surface.
If washing the clothing doesn’t help remove the correction fluid, try spraying WD-40 or Windex onto the affected area and letting it soak in. After a few minutes, gently wash the area again. [7] X Research source
