Your box can be any size, but be aware that the bigger it is, the more glue and rope you will need.
If you don’t have a lot of glue, you can glue the cord down every few inches. [3] X Research source Avoid squeezing out too much hot glue at one time; hot glue sets fast.
You can use any type of fabric you want. Because of how rustic jute cord is, cotton, linen, or canvas would work best.
You can use any size of box you want. Keep in mind that, the bigger your box is, the more rope you will need to use.
Be sure to cut slightly into the fabric/felt lining as well. This will allow you to “catch” the lining as you weave and prevent raw edges. [7] X Research source The slits need to be about ⅛-inch (0. 32-centimeter) wide to accommodate the string you will be weaving around the “fingers. " If you are using a very big box, you may have to use thicker cord so that it will be more proportionate. Make your slits about ¼-inch (0. 64-centimeter) wide to accommodate the thickness of the cord.
Depending on the thickness of your box, you may be able to use a regular hole puncher. If your box is too thick, you can punch the holes with a nail instead.
The thinner the cord is, the better.
Be sure to weave tightly at the corners. Be sure to weave over the fabric/felt. This will pin the material to the “fingers” and widen the raw edges.
If you run out of cord, tie the end of a new cord to it, and continue weaving. Tuck the tail ends of the knot under the cord as you weave.
Keep your weaving on this part loose.
